Adlink nanoX-BASE Bedienungsanleitung

Flat Panel Transfer Board (FPTB) User's Manual Manual Revision: 2.00 Revision Date: August 9, 2012 Part Number: 50-1J040-1000

2.2 Connector Pin Definitions CN1: Power Connector (Floppy power connector) Pin Signal 1 +5V 2 GND 3 GND 4 +12V CN4: LVDS Input Connector (2x17 b

CN5: TTL Output Connector (2x20 box header, 2.00 mm pitch) Pin Signal Pin Signal 1 GND 2 FCLK 3 GND 4 FR0 5 FR1 6 FR2 7 GND 8 FR3 9 FR4 10 FR5 11

CN6: LVDS Output Connector (2x17 box header, 2.00 mm pitch) Pin Signal Pin Signal 1 LVDS_CLK_A 2 LVDS_DTA_A 3 PNL_PWR 4 PNL_PWR 5 GND 6 LVDS_A-N0

2.3 Jumper Settings JP1: Backlight Voltage Jumper Configuration 1 - 2 +12V 3 – 4 Reserved 5 – 6 +5V* JP2: Panel Voltage Jumper Configuration

3 Getting Started The example instructions below describe how to use the FPTB to connect an ADLINK reference carrier board to a TTL display: In this

3.2 LVDS Input to FPTB Use the LVDS-to-LVDS cable that came with the FPTB to connect the LVDS output connector on the ADLINK carrier board (CN6 on na

3.3 TTL Output to Display Panel Make the appropriate cable to connect the TTL Output Connector (CN5) and Backlight Control Connector (CN8) on the FPT

Technical Support Contact us should you require any service or assistance. ADLINK Technology, Inc. Address: 9F, No.166 Jian Yi Road, Zhonghe Distri

ADLINK Technology, Inc. (French Liaison Office) Address: 15 rue Emile Baudot, 91300 Massy CEDEX, France Tel: +33 (0) 1 60 12 35 66 Fax: +33 (0

Document History Revision Date Changes 2.00 2012/08/09 Initial Release 2 FPTB User's Manual

Preface Copyright 2012 ADLINK Technology, Inc. Disclaimer The information in this document is subject to change without prior notice in order to im

Table of Contents Preface ... 3 1 Intr

1 Introduction 1.1 Overview The Flat Panel Transfer Board (FPTB) is intended for prototyping and verification of LVDS and TTL flat panel displays wi

1.3 Mechanical Drawing Dimensions in mm. 6 FPTB User's Manual

1.4 Applications The FPTB is intended for use in the following situations: • nanoX/Express-BASE → FPTB → Customer’s cable to TTL display: This confi

• Customer carrier (with LVDS output) → Customer’s cable to FPTB → FPTB → Customer’s cable to TTL panel: This configuration provides LVDS-to-TTL con

2 Connectors and Jumpers 2.1 Board Layout FPTB (Flat Panel Transfer Board) Connector and Jumper Locations Connector Description CN1 Power Connect