Adlink ASD26-MT1 ET Series Bedienungsanleitung

Advance Technologies; Automate the World. ASD26-MT1 Series 2.5" SATA 6 Gb/s Solid State Drive Specification Revision: 1.0 Date: 2

10 Specification Parameter Value Mean Time between Failure (MTBF) > 1,500,000 hours Power on/off cycles 50,000 cycles Minimum useful life 3 y

Specification 11 1.2.14. Electromagnetic Immunity: Electromagnetic Immunity tests assume the SSD is properly installed in the representative host

12 Specification 1.2.17. Part Numbers: Product Name Part No. ASD26-MT1032-CT 92-99059-7010 ASD26-MT11064-CT 92-99059-7110 ASD26-MT1128-CT 92-9

Specification 13 1.4 Product Image

14 Specification 1.5 Mechanical Drawing: Dimensions: 100.0 x 69.8mm x 9.5 mm (L x W x H)

Specification 15 1.6 Architecture The ASD26 series 2.5" SATA Solid State Drive (SSD) utilizes a cost effective system-on-chip (SoC) design to

16 Specification 2 Pin Locations and Signal Descriptions 2.1 Pin Locations The data and power connector pin locations of the ASD26 series 2.5"

Specification 17 Power Connector: Name Type Description P1 V33 3.3V Power P2 V33 3.3V Power P3 V33 3.3V Power, Pre-change P4 GND P5 GN

18 Specification 3 ATA Command Sets 3.1 ATA Command The ASD26 series 2.5" SATA SSD supports all the mandatory ATA commands defined in the ATA

Specification 19 3.1.2 Identify Device Data The following table details the sector data returned after issuing an IDENTIFY DEVICE command. Word F=

2 Specification Document History Revision Date Changes 0.01 2013/30/05 Preliminary Release 0.02 2013/6/20 Updated IOPS 0.1 2013/8/7 Added M

20 Specification Word F=Fixed V=Variable X=Both Default Value Description 64 F 0007h Multi-word DMA modes supported/selected 65 F 0003h PIO m

Specification 21 Word F=Fixed V=Variable X=Both Default Value Description 95 V 0h Vendor’s recommended and actual acoustic management value 96 F

22 Specification Word F=Fixed V=Variable X=Both Default Value Description 235 F 0h Reserved 236-254 0001h Reserved 255 02A0h Reserved

Specification 23 3.3 Security Mode Feature Set The ASD26 series 2.5" SATA SSD supports the Security Mode command set, which consist of ．SECU

24 Specification Table 16: SMART commands 3.5 Host Protected Area Command Set The ASD26 series 2.5" SATA SSD supports the Host Protected Area

Specification 25 ．READ NATIVE MAX ADDRESS ．FLUSH CACHE EXT ．READ DMA EXT ．READ NATIVE MAX ADDRESS EXT ．READ SECTOR(S) EXT ．READ VERIFY SECTOR(S) EX

26 Specification 4 SATA Command Sets 4.1 SATA Command The SATA 3.0 Specification is a super set of the ATA/ATAPI-8 specification with regard to sup

Specification 27 5 References This document references standards defined by a variety of organizations as listed below. Tabl

28 Specification 6 Getting Service Contact us should you require any service or assistance. ADLINK Technology, Inc. Address: 9F, No.166 Jian Yi R

Specification 29 LiPPERT ADLINK Technology GmbH Address: Hans-Thoma-Strasse 11, D-68163, Mannheim, Germany Tel: +49-621-43214-0 Fax: +49-621

Specification 3 Copyright 2013 ADLINK Technology, Inc. Disclaimer The information in this document is subject to change without prior notice in o

4 Specification Table of Contents 1 Introduction... 5 1.1 Overview...

Specification 5 1 Introduction 1.1 Overview The ASD26 (ASD26-MT1) series 2.5" SATA Solid State Drive (SSD) delivers leading performance in an

6 Specification 1.2.3. Flash: Multi-Level Cell (MLC) component with Toggle-Mode (19nm) 1.2.4. Band Performance ASD26-MT1XXX-CT: Capacity Access

Specification 7 1.2.5. Read and Write IOPS ASD26-MT1XXX-CT: Capacity Access Type IOPS 4K Read (IOPS) 40,000 (SATA 6 Gb/s) 32GB 4K Write (IOPS)

8 Specification 1.2.6. Power On to Ready: Type Average Latency Power on to Ready 1s Table 4: Latency Specifications Notes: 1. Write cache enable

Specification 9 1.2.10. Power Consumption Capacity Description Min Max Unit 32GB Operating voltage for 5V (+/- 5%) 4.75 5.25 V 64GB Operat