Adlink cPCIS-1100A Series Bedienungsanleitung PDF herunterladen (Seite 42)

38 • Power Supply Unit

• Power Fail Signal: available at [FAL#] pin

• Status LED: <green> means valid input voltage; <amber> means a

critical fault.

• Thermal Protection (OTP): Installed NTC and thermostat for thermal

sensor at [DEG#] pin

• Power OK: Installed at all outputs

• Leakage Current: 1.18mA at 254Vac/60Hz

Output Characteristics

Output Current (A)

Output

Voltage

Min. Max. Typ. Peak.

0 40.0 25.0 –

3.3V

0 40 20 –

12V

0 5.5 4 –

-12V

0 2 1 –

 Over Load Protection: fully protected against output overload or short circuit,

typical 120% max. load

 Over Current Protection: installed at each rail

o Output Wattage: Typ. 250W continuous.

o Output Connector: CompactPCI 47-pin power connector.

o Line Regulation: Max. ±10mV

o Load Regulation: 3.3V & 5V: ± 10mV, +12V: ± 30mV & -12V: -380

mV.

o Noise & Ripple: 60 mV@5V and 3.3V output; 120mV@.± 12V

output.

o OVP: Built-in at all outputs.

o Adjustability: Available at VO1, 2 & 3.

o Output Trim: Electrical trim available at VO1/VO2 [ADJ #].

o Remote Sensing: Available at VO1, VO2 & VO3.

o Hot-Swap: Available.

o N+1 Redundancy: Installed with internal OR-ing diodes at all outputs

for N+1 redundancy operation.

o Current Sharing: Third-wire current sharing at VO1,2 &3.

o Power OK Signal: Available for all output.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Keine Kommentare

Adlink cPCIS-1100A Series Bedienungsanleitung Seite 42