Adlink CoreModule 430 Bedienungsanleitung PDF herunterladen (Seite 29)

Chapter 3 Hardware

CoreModule 430 Reference Manual 23

Note: The shaded table cell denotes ground. The * symbol indicates the signal is Active Low.

USB Interface

The CoreModule 430 contains one root USB (Universal Serial Bus) hub and two functional USB ports. The

Vortex CPU provides the USB function including the following features:

• Provides one root hub with two USB ports

• Supports USB EHCI v.2.0 and USB OHCI v.1.1

• Provides over-current detection status

• Provides a fuse (F1, 1.5A) on board for over current protection

Table 3-8 describes the pin signals of the USB0 interface, which uses a single-row, 5-pin, right-angle header

with 0.100" (2.54mm) pitch.

Note: The shaded table cells denote power or ground.

Table 3-9 describes the pin signals of the USB1 interface, which uses a single-row, 5-pin header with 0.079"

(2mm) pitch.

4 RTS* 7 Request To Send – Indicates serial port is ready to transmit data. Used as

hardware handshake with CTS for low level flow control.

5 TXD 3 Transmit Data – Serial port transmit data output is typically held to a

logic 1 when no data is being sent. Typically, a logic 0 (On) must be

present on RTS, CTS, DSR, and DTR before data can be transmitted on

this line.

6 CTS* 8 Clear To Send – Indicates external serial device is ready to receive data.

Used as hardware handshake with RTS for low level flow control.

7 DTR* 4 Data Terminal Ready – Indicates serial port is powered, initialized, and

ready. Used as hardware handshake with DSR for overall readiness.

8 RI* 9 Ring Indicator – Indicates external serial device is detecting a ring

condition. Used by software to initiate operations to answer and open the

communications channel.

GND 5 Ground

10 Key/NC NC Key Pin – Not connected

Table 3-8. USB0 Interface Pin/Signal Designations (J10)

Pin # Signal Description

USB0PWR USB Power – VCC (+5V +/-5%) power goes to the port through an on board

fuse. Port is disabled if this input is low.

2 USB0N USB0 Port Data Negative

3 USB0P USB0 Port Data Positive

GND USB0 Port ground

5SHIELDUSB0 Port shield

Table 3-9. USB1 Interface Pin/Signal Designations (J17)

Pin # Signal Description

USB1PWR USB Power – VCC (+5V +/-5%) power goes to the port through an on board

fuse. Port is disabled if this input is low.

2 USB1N USB1 Port Data Negative

3 USB1P USB1 Port Data Positive

Table 3-7. Serial Ports 3 & 4 Interface Pin/Signal Descriptions (J13, J14) (Continued)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Adlink CoreModule 430 Bedienungsanleitung Seite 29

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Adlink CoreModule 430