Adlink CoreModule 430 Bedienungsanleitung PDF herunterladen (Seite 43)

Chapter 4 BIOS Setup

CoreModule 430 Reference Manual 37

• PIO Mode – [Auto; 0; 1; 2; 3; 4]

• DMA Mode – [Auto]

• S.M.A.R.T. – [Auto; Disabled; Enabled]

• 32Bit Data Transfer – [Disabled; Enabled]



Primary IDE Slave : [Not Detected]

• Type – [Not Installed; Auto; CD/DVD; ARMD]

• LBA/Large Mode – [Disabled; Auto]

• Block (Multi-Sector Transfer) – [Disabled; Auto]

• PIO Mode – [Auto; 0; 1; 2; 3; 4]

• DMA Mode – [Auto]

• S.M.A.R.T. – [Auto; Disabled; Enabled]

• 32Bit Data Transfer – [Disabled; Enabled]



Secondary IDE Master : [Not Detected]

• Type – [Not Installed; Auto; CD/DVD; ARMD]



Secondary IDE Slave : [Not Detected]

• Type – [Not Installed; Auto; CD/DVD; ARMD]

• Hard Disk drive Write Protect – [Disabled; Enabled]

• IDE Detect Time Out (Sec) – [0; 5; 10; 15; 20; 25; 30; 35]

• ATA (PI) 80Pin Cable Detection – [Host & Device; Host; Device]

• Hard Disk Delay – [Disabled; 1 Second; 2 Second; 4 Second; 8 Second]

• OnBoard IDE Operate Mode – [Legacy Mode; Native Mode]

• Not Program PIO mode – [Disabled; Primary Channel; Secondary Channel]

• Primary IDE Pin Select – [Parallel IDE; SD Card]

Remote Access Configuration

• Remote Access – [Hotcable; Enabled]

• Serial port number – [COM1; COM2]

Base Address, IRQ [3F8h, 4]

• Serial Port Mode – [115200 8, n, 1; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1; 09600 8, n, 1]

• Flow Control – [None; Hardware; Software]

• Redirection After BIOS POST – [Disabled; Boot Loader; Always]

• Terminal Type – [ANSI; VT100; VT-UTF8]

Note

: If VT-UTF8 is selected, the following item disappears from the screen.

• VT-UTF8 Combo Key Support – [Disabled; Enabled]

• Sredir Memory Display Delay – [No Delay; Delay 1 sec; Delay 2 sec; Delay 4 sec]

USB Configuration

• USB Port 0, 1 – [Enabled; Disabled]

• USB Port 2, 3 – [Enabled; Disabled]

• USB Device – [Enabled; Disabled]

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Adlink CoreModule 430 Bedienungsanleitung Seite 43

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Adlink CoreModule 430