Adlink CoreModule 430 Bedienungsanleitung PDF herunterladen (Seite 33)

Chapter 3 Hardware

CoreModule 430 Reference Manual 27

Note: The shaded table cells denote power or ground. The * symbol indicates the signal is Active Low.

12 FP5 Panel Data 5 – Refer to pin 9, FP2, for more information.

13 FP6 Panel Data 6 – Refer to pin 9, FP2, for more information.

14 FP7 Panel Data 7 – Refer to pin 9, FP2, for more information.

15 NC Not connected (FP8 = Panel Data 8)

16 NC Not connected (FP9 = Panel Data 9)

17 FP10 Panel Data 10 – Refer to pin 9, FP2, for more information.

18 FP11 Panel Data 11 – Refer to pin 9, FP2, for more information.

19 FP12 Panel Data 12 – Refer to pin 9, FP2, for more information.

20 FP13 Panel Data 13 – Refer to pin 9, FP2, for more information.

21 FP14 Panel Data 14 – Refer to pin 9, FP2, for more information.

22 FP15 Panel Data 15 – Refer to pin 9, FP2, for more information.

23 NC Not connected (FP16 = Panel Data 16)

24 NC Not connected (FP17 = Panel Data 17)

25 FP18 Panel Data 18 – Refer to pin 9, FP2, for more information.

26 FP19 Panel Data 19 – Refer to pin 9, FP2, for more information.

27 FP20 Panel Data 20 – Refer to pin 9, FP2, for more information.

28 FP21 Panel Data 21 – Refer to pin 9, FP2, for more information.

29 FP22 Panel Data 22 – Refer to pin 9, FP2, for more information.

30 FP23 Panel Data 23 – Refer to pin 9, FP2, for more information.

TFTEnVcc TFT Power (Vcc) – This signal is the power to flat panel displays.

32 TFTEnVee TFT Backlight Enable – This signal enables power to flat panel displays.

+PNLVdd Voltage (+3.3 or +5 volts ±5%) depends on setting of JP6.

+12V Out +12 volts ±5%

GND Ground

37 HSYNC Horizontal Sync – This signal is used for the digital horizontal sync output to the

CRT. Also used (with VSYNC) to signal power management state information to

the CRT per the VESA DPMS standard.

38 VSYNC Vertical Sync – This signal is used for the digital vertical sync output to the CRT.

Also used (with HSYNC) to signal power management state information to the

CRT per the VESA DPMS standard.

AGNDR Analog Ground for Red

40 RED Red – This pin provides the Red analog output to the CRT.

AGNDG Analog Ground for Green

42 GREEN Green – This pin provides the Green analog output to the CRT.

AGNDB Analog Ground for Blue

44 BLUE Blue – This pin provides the Blue analog output to the CRT.

Table 3-12. Video Interface Pin/Signal Descriptions (J11) (Continued)

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 55 56

Keine Kommentare

Adlink CoreModule 430 Bedienungsanleitung Seite 33